Installation
• The installation of this product must be performed by qualified
personnel.
• Always refer to the installation section in the operator's manual
before applying power to the equipment.
• This is a Safety Class I product (provided with a protective
earthing terminal). An uninterruptible safety earth ground must be
provided at the AC in/output terminals. An additional grounding
point is located at the outside of the product. Whenever it is likely
that the grounding protection has been impaired, the product must
be made inoperative and secured against any unintended
operation; refer to qualified service personnel.
• Make sure that fuses and circuit breakers are provided in the
connecting wires. Never replace a safety component by a different
type. Consult the manual for determining the correct component.
• Make sure that all cables and wiring in the installation are
anchored such that the conductors are relieved from strain and
twisting.
• Before applying power, verify that the available power source
matches the configuration settings of the product as described in
the manual.
• Ensure that the environmental conditions are suitable for
operation of the equipment. Never operate the product in a wet or
in a dusty environment.
• Always allow enough free space around the product for
ventilation and make sure that ventilation vents are not blocked.
• Be sure that the demanded power does not exceed the capacity
of the product.
• This device is a continuous duty automatic charger for
rechargeable open, sealed and gel lead acid batteries
• For supply connection use wires suitable for at least 75°C
(167°F).
• CAUTION: Replace defective cords or wires immediately.
2