Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
HOW TO USE THE DIVE LIGHT
General
-
After each dive, soak the lamp in clean fresh water for a few minutes. Leave the light
head connected to the battery pack while rinsing it to avoid exposing the contacts
of the battery and cable to water.
-
Avoid exposing the contacts of the cable or battery pack to water, as this may damage
or cause short-circuiting of the battery tank.
-
Rinse the dive light under running water to remove all traces of sand and salt.
-
Avoid physical impact.
-
Avoid overheating and direct exposure to sunlight.
-
To make sure the light doesn't overheat or cause burn damage to objects in its
immediate vicinity, it is strongly advised to use it only while submerged under water.
-
Never disconnect the light from the battery pack underwater.
-
Never store the battery pack uncharged for a long period.
-
Always use the charger that is delivered with the dive light.
1
Charging the battery pack
The charger is suitable for power outlets with a voltage between 100 and 240 Vac. The
battery pack is delivered uncharged, so it is important to charge the battery pack
completely with a full charge cycle. Make sure that the connector is clean and dry.
Securely plug the charge connector into the battery tank.
The charger is fitted with a Delta-V charge controller and safety timer. The charge
controller switches to pulse charging as soon as the battery reaches its full power. Please
wait until the small light (LED) on the charger lights green continuously before you
disconnect the charger from the battery pack.
While charging the indication LED on the charger lights red continuously.
The battery pack fully charged and using trickle charge when the indication LED on the
charger lights green continuously.
Warning:
ALWAYS USE THE CHARGER THAT IS DELIVERED WITH THE DIVE LIGHT! THE USE
OF OTHER CHARGERS CAN DAMAGE THE BATTERY CELLS INSIDE!
ENG
.
5
Advertenties
Hoofdstukken
Inhoudsopgave
