Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
2
Installation
This section of the manual will cover the installation of your Lukas internet radio starting from how
to mount and connect your device, following with configuration and service tasks.
2.1 Preparing the Lukas
After you have unpacked your Lukas, it can be placed to the desired location. This location
should have a flat surface (e.g. a table) and should be near a network modem/switch socket.
2.2 Connecting your Lukas
As with every electronic device, there are some directives you need to be follow in order to
properly connect your Lukas device.
2.2.1
Connecting the Lukas on ethernet network
Use the provided ethernet cable to connect your Lukas with your cable modem, ADSL modem or
router. If everything is ok (and the power supply has also been connected) the yellow led of the
ethernet connector will light-up yellow continuously while being connected. The green led will
blink randomly.
Always leave the ethernet connector plugged in the Lukas. If you do not leave the connector
in the Lukas, it can take up to 1 minute before you can control the device again.
2.2.2
Connecting the Power supply
Plug the power adaptor to the mains outlet and then plug the connector to the Lukas. The
message "One moment..." will appear on the screen, and in a few seconds the Lukas will switch
off.
In the process of connecting the power to the Lukas we ask that you pay careful attention to the
following instructions:
Never use wet hands when plugging the power adapter in the mains and never remove the
power adapter from the mains with wet hands.
Do not cut or damage the cord of the power adapter; do not place heavy objects on the
cord. This can cause short-circuit, resulting in electrical shocks or even fire.
Pulling the cord can also damage the wire and/or isolation causing electrical shocks or fire.
Using power adapters other than the one recommended for your Lukas device, can result in
overheating and damage you device. This can cause fire, electrical shocks and other hazards.
Only use the supplied power adapter.
Applying the Lukas to situations with rapid changing temperatures can result in
condensation (small amount of water) on the inner and outer surface of your device. To ensure a
long lifetime of your Lukas, this should be prevented. In case of such a scenario, wait until you
device is 'dry' before you use it again.
User's manual
LUKAS II
Aug 2016
Version 2.0
6
Advertenties
Inhoudsopgave
