Technical Data - Zanussi ZBA15021SA Gebruiksaanwijzing
Verberg thumbnails
Zie ook voor ZBA15021SA:
- Gebruiksaanwijzing (45 pagina's) ,
- Gebruiksaanwijzing (41 pagina's) ,
- Gebruiksaanwijzing (40 pagina's)
Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Problem
Water flows on the rear
plate of the refrigerator.
Water flows into the re-
frigerator.
Water flows on the
ground.
The temperature in the ap-
pliance is too low.
The temperature in the ap-
pliance is too high.
Replacing the bulb
If you want to replace the bulb, do these steps:
1. Break the circuit of the appliance.
2. Unscrew the lamp cover securing screw.
3. Unhook the moving part by pressing it as
shown in the figure.
4. Replace the bulb with one of the same
power and specifically designed for
household appliances (the maximum pow-
er is shown on the light bulb cover).
5. Fix the lamp cover in place.
6. Screw the lamp cover securing screw.
7. Reconnect the appliance.
8. Open the door and check if the light
comes on.
Technical data
Dimension of the recess
Voltage
Frequency
www.zanussi.com
Possible cause
During the automatic defrosting
process, frost defrosts on the rear
plate.
The water outlet is clogged.
Products prevent that water flows
into the water collector.
The melting water outlet does not
flow in the evaporative tray above
the compressor.
The temperature regulator is not
set correctly.
The temperature regulator is not
set correctly.
Height
Width
Depth
This is correct.
Clean the water outlet.
Make sure that products do not
touch the rear plate.
Attach the melting water outlet to
the evaporative tray.
Set a higher temperature.
Set a lower temperature.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
873 mm
540 mm
549 mm
230 V
50 Hz
Solution
17
Advertenties
Hoofdstukken
Inhoudsopgave
