Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
OPERATION
Electronic programmer
work time
-
A
turn-off time
-
timer
-
current time
-
1 - programmer work function selection
button
2 - button „-"
3 - button „+"
Current time set-up
After plugging in or reconnecting to a power
source after current decay, the dis play shows
12.00, and the lamp at
• set up the current time using buttons 2
and 3.
1200
About 5 sec. after the time set-up has been
finished, new data will be memo rized and the
lamp at
will go out.
The time correction can be done later, press-
ing button 1 until the lamp at
Then you can correct the current time.
Notice!
If the current time is not set up, it is im possible
for the oven to work.
flashes,
starts to flash.
21
8888
A
2
Timer
You can activate the timer at any time, regard-
less the activity state of other pro grammer
functions. The measured time ranges from 1
minute to 23 hours 59 minutes. With the aim
of setting up the timer:
• press button 1 until the lamp at
flash, and the dis play shows "0.00",
•set up the timer using buttons 3 and 2,
The set-up time is pre sented on the display,
and the lamp at
005
After the set-up time has elapsed, a sound
signal turns on and the lamp at
flash again,
• press buttons 1, 2 or 3 to turn the signal
off; the lamp will go out, and the display will
in di cate the current time.
Notice!
If the sound signal is not turned off manu-
ally, it will turn off au to matically after about
2 minutes.
1
3
starts to
is turned on.
starts to
Advertenties
Hoofdstukken
Inhoudsopgave
