Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Issue
Motor stops immediately after
starting
Motor runs but there is not suc-
tion
Motor runs but there is poor suc-
tion
Dust blown from motor
Poor pumping
Abnormal noise
Transportation of the product
•
The unit must be securely fasten during
transportation.
•
Where possible, always transport in closed vehicle.
•
Avoid transporting in adverse weather condition.
•
Use ramps or winches to lift the dust extractor to
make sure that movements are safe. Get aid if you
are not sure about how to lift heavy equipment.
•
Engage the locking caster safely on the wheels.
•
Secure the equipment during transportation in order
to avoid transport damage and accidents.
•
It is recommended to transport the product upright
where possible.
•
It is recommended to empty the product before
transportation.
Storage of the product
•
The product must be stored inside away from
outdoor elements.
•
Wet filters and the interior part of the liquid container
shall be dried before storage.
3
Only applicable on W 70 and W 70 P.
4
Only applicable on W 70 P and W 250 P.
10
Cause
Wrong fuse
Shortcut in cable/machine
Hose not connected
Hose blocked
Floating device activated.
Hole on the hose
Filter clogged
Loose suction unit
Dirt in the hose or intake
Defective gaskets
Blocked or defective check valve.
Wrongly assembled or damaged filter system
The pump or tubes are blocked
Transportation, storage and disposal
3
4
•
Do not expose the product to rain or moisture.
•
Attach the locking casters safely. Only applicable on
W 70 and W 70 P.
•
Disconnect the product from the power source.
•
Store the product and the equipment in a dry area
with no frost or excessive heat.
•
Store all equipment in an locked area, so that it is
out of reach of children and unauthorized persons.
Disposal of the product
•
Obey the local recycling requirements and applicable
regulations.
•
When the product no longer is used, send it to a
dealer or discard it at a recycling location.
Solution
Connect to correct fuse
Order service
Connect the hose
Clean hose
Inspect water level and dam-
ages on the float.
Replace hose
Clean filter/ Replace filter
Adjust
Clean the hose and intake
Replace affected gaskets
Clean or replace the check
valve.
Adjust/ Replace filters
Clean the pump, check valve
and hose
Order service
1056 - 005 - 26.08.2021
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
