Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
4. ELECTRICAL CONNECTIONS
4.1 Electrical panel
• Insert the cables with the pre-wired terminal boards in the housing (fig. 17) and connect them to the boards (as shown in
chap. 5). Fit the cables in the conduit and connect the connectors on the motor (fig.18).
Cabling connection on the board must be done with main power cut off, for at least 30 sec.
4.2 Electrical panel/motor/safety device connections
• Figure 19 shows the layout of the cables supplied and their position in the door; each cable is identified by a special code
on an adhesive label.
4.3 Safety photocells
• Make the electrical connections as shown in (fig.19).
• Make the connections in the control panel as shown in the diagrams in chap. 5.
230 V
Inverter
TRAFFIC C
M
ENC
400 V
400 V
Correctly size the line conductor cross-section by referring to the indicated absorption and taking the length and
installation of the cables into account.
17
F
400 V
0 1
Rx2
0 1
C T
Tx1
- 33 -
230 V
Inverter
A935G/E
0 1
Tx2
0 1
Rx1
7823C/D
7824C/D
7824C/D
0DT829 01-12-2021
EN
18
19
Advertenties
Hoofdstukken
Inhoudsopgave
