Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
EN
b.) Press the button (2) until the LED (1)
flashes red.
c.) Before the LED (1) stops flashing, press the
"OFF" button for 3 seconds for the switch
channel you wish to delete on the wireless
transmitter that the wireless flush-type
switch previously learnt. The LED (1)
goes out and the delete process has been
completed successfully.
d.) Repeat these steps for additional wireless
transmitters.
Deleting all the wireless
transmitters that the
wireless flush-type
switch has learnt
All channels that have been learnt can
also be deleted again.
a.) Connect the "Roller shutter" wireless
flush-type switch to a standard 230 V AC
20
mains voltage in the correct manner, as
described in the section above.
b.) Press the button (2) until the LED (1)
flashes red.
c.) Before the LED (1) stops flashing, press the
button (2) again on the wireless flush-type
switch. The LED (1) goes out and the delete
process has been completed successfully.
FUNCTION TEST
Connect the "Roller shutter" wireless flush-
type switch to a standard 230 V AC mains
voltage in the correct manner, as described
in the section above. You can now test the
function of the wireless flush-type switch
by briefly pressing the corresponding "ON"
button for the relevant switch channel. The
red LED (1) lights up. The switch contact for
the selected direction of movement of the
shutter/roller shutter is switched for max.
90 seconds. Pressing the "OFF" button for
Advertenties
Inhoudsopgave
