Inhoudsopgave
Advertenties
1. Relation between Plate thickness with cutting edge data (Picture 3)
Thickness
(Cutting edge data can cut 2mm when the machine was made out)
7.
I
nstellen KnIpdIKte
（mm）
2. Regulation means: (Picture 4)
Plaatdikte
Thickness
(mm)
Loose screw 1 and nut 3 slightly. Tight nut 4 at the condition of bolt 5 is fixed.
（mm）
The cutting edge thickness will increase; Loose screw 1 and nut 4 slightly. Tight
nut 3 at the condition of bolt 2 is fixed. The cutting edge thickness will reduce.
Check cutting edge date with gauges feeler, tight all the nuts and screws after
make sure it matches with plate thickness. Pleae note both sides must be
Afbeelding 3
adjusted to consistent and the Nut #6 must be loosen before adjustment and
Verhouding plaatdikte - snijsnede (de snijsnede staat standaard ingesteld op 2 mm).
2. Regulation means: (Picture 4)
then fixed after adjustment.
7.1
I
nstellen
Loose screw 1 and nut 3 slightly. Tight nut 4 at the condition of bolt 5 is fixed.
The cutting edge thickness will increase; Loose screw 1 and nut 4 slightly. Tight
nut 3 at the condition of bolt 2 is fixed. The cutting edge thickness will reduce.
Check cutting edge date with gauges feeler, tight all the nuts and screws after
make sure it matches with plate thickness. Pleae note both sides must be
adjusted to consistent and the Nut #6 must be loosen before adjustment and
then fixed after adjustment.
Afbeelding 4
Draai schroef 1 en moer 3 een slag los. Draai moer 4 aan, terwijl bout 5 vast blijft. De snijsnede zal toenemen,
draai schroef 1 en moer 4 lichtjes los. Draai moer 3 dusdanig dat bout 2 vast blijft. De snijsnede zal afnemen.
Controleer snijsnede gegevens met meetinstrument, draai alle moeren en schroeven vast als de ingestelde waarde
overeenkomt met de plaatdikte. Let op, beide zijden moeten worden versteld en moer #6 moet los worden gedraaid
om te verstellen en worden vastgedraaid na verstelling.
6
2
1
0.05
0.10
Picture 3
2
1
0.05
0.10
Picture 3
1
Picture 4
1
WIJZIGINGEN EN TYPEFOUTEN VOORBEHOUDEN
Cutting edge （mm）
Snijsnede (mm)
Cutting edge （mm）
3
2
4
5
1
5
2
3
4
1
Picture 4
5
6
6
5
Advertenties
Inhoudsopgave
