Advertenties
Beschikbare talen
Beschikbare talen
Troubleshooting
The follow overview will help you understand possible problems. However, only qualified
technicians should attempt to open or repair the machine. Contact your supplier when in doubt.
Problem
The appliance does not work.
Compressor works but appliance
is not cooling.
The appliance does not reach set
temperature.
The inside temperature is too low.
Fault code: HI
Temperature above 45ᵒC / 113ᵒF
Fault code: LO
Temperature under -45ᵒC / -49ᵒF
Fault code: E01
Communication failure
Press and hold + and - key simultaneously for 3 seconds to restore factory default settings. The temperature
and time display wil both show display "rS" code and then the appliance shuts down automatically. Restart the
appliance normally and check if error has disappeared. If this does not solve the issue, contact you supplier.
Spangenberg International B.V. – Nijverheidsweg 19F – 3641 RP Mijdrecht – Holland – T. +31 (0) 297 253 969 – F. +31 (0) 297 256 445
Possible Cause
▪
The appliance is switched off.
▪
The power supply is
interupted.
▪
The voltage is not correct.
▪
Cooling system defect.
▪
Cooling system dirty.
▪
Door not closed properly.
▪
The temperature is not set
correctly.
▪
Insufficient air circulation.
▪
Cooling system dirty.
▪
Too much food inside.
▪
The temperature is not set
correctly.
▪
Quick Freeze mode is
activated.
▪
The appliance is near a heat
source.
▪
Defective temperature
sensor.
▪
Incorrect settings.
▪
Defective temperature
sensor.
▪
Incorrect settings.
▪
Electronic error.
▪
Faulty wiring
info@maximaholland.nl
-
www.maximaholland.com
Possible Solution
➢ Switch on the appliance.
➢ Check the power supply, plug
in power cable.
➢ Use a compatible power
source.
➢ Contact supplier.
➢ Clean the appliance.
➢ Check the door (seal).
➢ Check and adjust the
temperature settings.
➢ Reposition the appliance.
➢ Clean the appliance.
➢ Process smaller amounts.
➢ Check and adjust the
temperature settings.
➢ Check and disable Quick
Freeze mode.
➢ Relocate the appliance or
heat source.
➢ Replace part.
➢ Reset and operate appliance.
➢ Replace part.
➢ Reset and operate appliance
➢ Reset to factory default
settings.
➢ Check wiring and contact
supplier.
Advertenties
