Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
6.2. ADJUSTING THE WATER TEMPERATURE
Adjusting the maximum water temperature for cooling
By reducing the water temperature setting, the unit will
start later. If the water temperature is set higher, the unit
will start sooner .
1. Put the device in the cooling mode
2. Hold down the [Mode] and [+] simultaneously until the
last 4 LEDs start flashing .
3. Short press the [-] or [+] button to adjust the set
temperature .
4. After 30 seconds, the new settings are automatically saved and the device returns to the selected mode. .
7. FACTORY RESET
1. Disable power charge .
2. Press and hold down both the [-] and [+] button on the circuit board and switch on
the power again. The blue LED will light up, followed by the green LED 2 seconds
later and the red LED 4 seconds later. Release the buttons as soon as all 3 LEDs are
flashing .
3. The controller will return to the Factory Default settings, all LEDs will flash for 8 seconds. .
30
12 ̊ C
MODE
14 ̊ C
MODE
16 ̊ C
MODE
18 ̊ C
MODE
20 ̊ C
MODE
22 ̊ C
MODE
24 ̊ C
MODE
26 ̊ C
MODE
Adjusting the minimum water temperature for heating
By increasing the water temperature setting, the unit will
start later. If the water temperature is set lower, the unit
will start sooner .
In combination with a heat pump, it may be necessary
to reduce the water temperature .
1. Put the device in heating mode
2. Hold down the [Mode] and [+] simultaneously until the
last 4 LEDs start flashing .
15 sec
24 ̊ C
26 ̊ C
28 ̊ C
30 ̊ C
32 ̊ C
34 ̊ C
36 ̊ C
38 ̊ C
/
FREEDOM | MANUAL | 2023.12.05 | V.3.03
factory default water temperature
-
Advertenties
Hoofdstukken
Inhoudsopgave
