Advertenties
Beschikbare talen
Beschikbare talen
Troubleshooting
The follow overview will help you understand possible problems. However, only qualified
engineers should attempt to open or repair the machine. Contact your supplier when in doubt.
Problem
The appliance does not work.
The appliance does not seal
properly.
The appliance is not vacuuming
properly.
Cleaning and Maintenance
•
Maintenance and repairs should only be done by certified engineers.
•
Always switch off and disconnect the power supply before cleaning or maintenance.
•
Regularly check and clean the appliance, its parts and accessories (if aplicable).
•
Regularly check the power plug and power cable for damage. If either is damaged do not use the appliance.
Instead, have it repaired by a certified electrical engineer.
•
Clean the machine using a damp cloth and some mild (food safe) detergent. Always dry the appliance and
accessories after cleaning using a soft cloth
•
ATTENTION! Never use aggressive cleaning agents or abrasives. Do not use solvents or petrol based cleaning
agents. Some cleaning agents may leave harmful residues or cause damage to the machine.
•
Do not use any scourer and sharp or pointed objects during cleaning, this may cause damage to the
machine.
•
ATTENTION! Never hose down the machine or immerse it in water or any other liquid, instead wipe the
exterior with a damp cloth. Do not use a steamer to clean the appliance
•
ATTENTION! Never let the power cable or power plug get wet or damp.
MAXIMA | Nijverheidsweg 23 A/D | 3641 RP Mijdrecht | The Netherlands
Possible Cause
▪
The appliance is switched off.
▪
The power supply is
interupted.
▪
The voltage is not correct.
▪
Unknown defect.
▪
Incorrect size bag/tube
▪
Incorrect sealing time
▪
Sealing wire/foam is worn or
damaged
▪
Incorrect size bag/tube
▪
Incorrect type bag/tube
▪
Vacuum chamber gasket worn
or damaged.
T: +31 (0) 297 253 969 |
info@maxima.com
Possible Solution
➢ Switch on the appliance.
➢ Check the power supply, plug
in power cable.
➢ Use a compatible power
source.
➢ Contact supplier.
➢ Make sure bag/tube fits
within sealing parameters.
➢ Adjust sealing time.
➢ Replace part
➢ Make sure bag/tube fits
within vacuum chamber
➢ Use micro channel or
embossed channel bag/tube.
➢ Replace part.
|
www.maxima.com
Advertenties
