Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
-
Insert the 2 upper screws, contained in the same bag, taking care to leave a distance of 8 mm between the
head of the screws and the wall;
-
Gripping the heater firmly, hook it onto the two screws; CAUTION! Before releasing the heater make sure
it is attached to the 2 screws.
-
Then secure the product with the lower screw.
3. F
ilter
•
This product is fitted with a filter to protect the heating element from dust and dirt.
•
The filter is removable to be easily cleaned with water (picture 5).
•
To keep the heater in perfect condition, clean the filter once every six months REMEMBERING TO PUT IT BACK
AGAIN AFTERWARDS.
•
Every 120 working hours, the user is notified of the need to clean the filter on the back of the product. The warning
is given in the form of a running message on the display that reads:
•
Even when the display is showing the message indicated above, the product continues to work in the mode active
at the time the notification appears.
•
If any key is pushed the text is removed from the display. It will once again be displayed when the fan heater has
been running for another hour.
•
By holding the
will be displayed again after another 120 working hours. Confirmation of resetting is given by a message on the
display for 5 seconds that reads "donE " .
4. t
oWels
•
The product is equipped with a towel rail and n. 4 additional hooks placed on rail's back side.
•
Please do not push or embed towel close to the air outlet grid (picture 6) but place them as shown in picture 7.
5. c
oMManD DescriPtion anD Functioning
•
The heater is fitted with a double pole electromechanical ON/OFF switch on its left side. Switching off the product
the supply voltage is disconnected from all the internal components.
•
The following controls are available on the front panel (picture 8):
A -
Presence Sensor
B -
Display
C -
Show and increase
D -
Show and decrease
E -
Settings
F -
Frost free mode
G -
Programmed mode
H -
Stand-by
I -
Frost free mode led indicator
J -
Programmed mode led indicator
K -
Functioning led indicator
This bathroom fan heater features a presence sensor and an automatic power management function.
The presence sensor allows a reduced energy consumption, lowering automatically the ambient temperature when no
one is detected in the room, while it comes back to the set comfort temperature, maintaining it throughout the time of
someone's detection.
The automatic electronic power selection, instead, manages the consumption through an accurate and comfortable
regulation in order to automatically keep constant the selected temperature, according to what has previously been set
on the electronic thermostat.
The operation of the presence sensor cannot be disabled and the product can be used in two distinct modes: auto-
matic or programmed.
Automatic Mode
The product is set to work at a comfort temperature whenever someone is detected in the room. Should no one be
detected in the room for at least 10 minutes, the heater will automatically set the Eco mode (3,5°C less than the set
Comfort temperature). Should no one be detected in the room for more than 36 hours, the heater will automatically set
the Frost free mode (7°C). In case someone should be detected again for at least 2 minutes, the product will automa-
tically increase the temperature to the comfort level.
" PULIrE FILtro - CLEAn FILtEr - nEttoYEr FILtrE " .
key down when the notification is displayed, the built-in counter is reset and the notification
17
Advertenties
Inhoudsopgave
