Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
5
INSTALLATION OF THE COOKER HOOD
The installation of the cooker hood on a discharge to the outside and a cooker hood with recirculation is identical.
1
Remove the fat filters.
Place the cooker hood at the required position at a minimum height of 65 cm above the cooking section and mark the
bottom side of the cooker hood on the wall/side wall. Determine the centre of the cooker hood.
Determine the centre of the cooking section and mark this point at the height of the cooker hood. This is to be able to
position the cooker hood centrally above the cooking section.
A = full width: 562 mm
B = full height: 187 mm
C = diameter discharge opening: Ø 150 mm.
2
Determine the position of the air discharge tube. Limit the number of bends and unnecessary lengths in the discharge
tube. As a result, the cooker hood will function better.
Saw out the holes for the discharge tube. The discharge opening (C) has a diameter of 150 mm. The hole for the
discharge tube must be 10 mm larger than the discharge tube.
3
Attach the discharge tube on the upper side of the discharge channel and allow it to hang down.
4 See how you want to mount the cooker hood - 4a, 4b or 4c.
4a The cooker hood can be attached via holes in the side of the base unit, by means of screws in the kitchen cabinet.
4b The cooker hood can be attached via holes in the rear wall of the base unit, by means of screws through the kitchen
cabinet into the wall.
4c The cooker hood can be attached via holes in the top side of the base unit, by means of screws in the kitchen cabinet.
Remove the cooker hood and pre-drill the holes. Use a drill with a 8 mm diameter. Drill the hole approximately 45 mm
deep.
5
Place the cooker hood back in the kitchen cabinet. When the discharge channel is no longer within reach, you must
connect the discharge tube to the cooker hood before you fully place the cooker hood in the kitchen cabinet.
Now fasten the cooker hood to the kitchen cabinet using the supplied screws.
6 Place the fat filters back.
Remove all protective film prior to using the cooker hood.
ELECTRICAL CONNECTION
Check that the voltage corresponds with what is stated on the information plate. Insert the plug into the socket. The
cooker hood is equipped with a connection plug. Install the cooker hood in such a way that the plug is always within reach.
Preferably place the wall socket out of sight, such as behind the discharge channel.
Caution: If you want to create a permanent connection, make sure an omnipolar switch with a contact distance of at least 3
mm is installed in the supply line.
22
•
English
6
Advertenties
Inhoudsopgave
