Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
7
troubleshooting
If your appliance is not working properly, it may be a minor problem, therefore check the following:
Problem
Appliance is not functioning; light
does not work
Temperature inside the
refrigerator is too high or too low
Water is running out of the
refrigerator
Appliance is excessively noisy
The inside light is not working
Note: gurgling and hissing noises due to expansion in the refrigerant circuit are normal.
8
installation instructions
Before installation, read the instructions carefully.
• Fit the refrigerator in stable kitchen units only with sufficient ventilation (figure B and C).
• If necessary, reverse the door according to the instructions.
• Check the installation dimensions of your model according to figure C.
1 See figure A for the necessary attachment components.
2 Insert the trim flap
1
into the slot and screw by screws
3 Pass the power cord through the ventilation shaft and position it so that the appliance could be easily plugged in once it has
been installed (figure B and C).
4 Take out the trim gasket
appliance (figures D and E).
5 Raise the appliance and slide into the kitchen unit.
6 Push the appliance to the reverse side of the door hinges providing that the trim gasket
appliance and the kitchen unit.
7 Allign the front feet with the front surface of the kitchen unit (figure F).
8 Screw the front feet by using screws
9 Screw the trim flap
1
to the kitchen unit using screws
10 Screw the guides
3
to the appliance door with screws
11 Lean the appliance door to the unit door as it is opened at the right angle 90°.
12 Slide the rails
4
into the guides
13 Screw the rails
4
to the unit doors with screws
14 Set 1-2 mm gap on the handle side between the unit itself and the unit doors by adjusting the guides
the appliances performance.
IKV1221S-1021S-0881S-instructions.indd 23
Cause
- Appliance is not plugged in
- There is a power failure
- The thermostat is set on ●
Thermostat has been set
incorrectly
Air circulation vents are blocked
Drain outlet is blocked
Has the appliance been installed
correctly?
Are the pipes at the back touch-
ing or vibrating?
Lamp is defective
2
located on the side panel of the appliance and stick it on the reverse side of the door hinges of the
5
(figure F).
3
aligning the groove (figure H2).
5
(figure H2).
Solution
- Plug the appliance in
- Check the fuse box
- Set the thermostat on setting 1-5
Set the thermostat correctly
Clean the ventilation openings
Clear the drain outlet with a skewer
Check the installation
Check it and move the appliance forwards
Replace the bulb following the instructions
6
(figure D).
5
(figure G).
6
(figure H1).
2
covers the space between the
3
(figure H). That is vital for
English
•
23
27-8-2014 9:47:30
Advertenties
Inhoudsopgave
