Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
bracket and at least 5 cm above the screws to hang the cooker hood on.
6 Place a socket, if necessary, out of sight behind the exhaust-air pipe. The socket must be postioned at least 1 cm below the
fitted bracket and at least 30 cm aboven the cooker hood.
7 Hang the cooker hood onto the screws.
8 Tighten the screws to make sure the cooker hood cannot fall.
9 Fit a flexible exhaust air-pipe onto the cooker hood to the exhaust opening.
Plug in the appliance.
10 When using the starter kit for recirculation the screws for the bracket must be loosened. Hang the recirculation kit on the
loosened screws. Tighten them again.
* The starter kit for recirculation is not included.
11 Place the chimney on top of the cooker hood. Make sure the inner chimney fits properly in the outer chimney.
12 Slide the inner chimney upwards and fit it to the bracket with two screws. Fit the outer chimney on the bottom to the cooker
hood with two screws.
Remove all the protective film before using the cooker hood.
ELECTRIC CONNECTION
Make sure the supply voltage ratings correspond with those stated on the rating plate. Plug the appliance in. The cooker hood is
provided with a plug. Make sure the plug remains accessible. Place the socket, if necessary, out of sight behind the exhaust-air pipe.
Attention: if you want to make a fixed connection, ensure that a multi-pole switch with a distance between contacts of 3 mm is
installed in the supply cable.
English
•
25
Advertenties
Inhoudsopgave
