7
9
INSTALLING THE COOKER HOOD TO A DUCT OF THE CENTRAL MECHANIC VENTILATION SYSTEM
1 Draw a vertical line on the wall from the middle of the cooker upwards with a minimum height of 65 cm + A.
Mark at this height horizontally the holes for the cooker hood bracket with a distance of exactly 80 mm (=X) of each other.
2 Drill with a masonry drill of Ø8mm the two marked holes.
3 Insert the plugs and fit the cooker hood bracket with the screws to the wall.
4 Hold the bracket for the inner chimney at the desired height on the wall. Mark the holes for the bracket. Drill the markes holes
and insert the plugs.
Fit the bracket for the inner chimney with two screws to the wall.
5 Place a socket, if necessary, out of sight behind the exhaust-air pipe. The socket must be postioned at least 1 cm below the
fitted bracket and at least 30 cm aboven the cooker hood.
6 Hang the cooker hood onto the cooker hood bracket.
7 Hang the cooker hood level using the two outer screws. Tighten the screw in or out to level the cooker hood.
Once the cooker hood is level, tighten the middle screw to secure the cooker hood.
8 Fit a flexible exhaust air-pipe onto the cooker hood to the exhaust opening of the CMV system.
Plug in the appliance.
9 Place the chimney on top of the cooker hood. Make sure the inner chimney fits properly in the outer chimney.
10 Slide the inner chimney upwards and fit it to the bracket with two screws. The outer chimney clicks automatically to the cooker
hood through magnets.
Remove all the protective film before using the cooker hood.
ELECTRIC CONNECTION
Make sure the supply voltage ratings correspond with those stated on the rating plate. Plug the appliance in. The cooker hood is
provided with a plug. Make sure the plug remains accessible. Place the socket, if necessary, out of sight behind the exhaust-air pipe.
Attention: if you want to make a fixed connection, ensure that a multi-pole switch with a distance between contacts of 3 mm is
installed in the supply cable.
24
•
English
8
10
2