CONTROL PANEL
(Figure 2)
A
Off button
B
Speed button 1
C
Speed button 2
Item
Off button
Speed button 1
Speed button 2
Speed button 3
Lamp button
WORKING PRINCIPLE COOKER HOOD
(Figure 3)
The appliance is used for handling the air of cooking fumes.
The appliance can be installed in two different ways.
Extracting (A)
The cooking fumes are extracted outside.
Warning:
Never connect the pipe to a duct that contains gas or other fuels.
Recirculating (B)
The cooking fumes go through a carbon filter. The filter purifies the fumes and recirculates these back to the kitchen.
A good outflow of the air is necessary.
Extra information
•
Note:
New houses may no longer vent outside.
•
For recirculation, it is necessary to use carbon filters. For more information on the carbon filters go to the website
www.inventum.eu.
•
Attention:
The carbon filters are not included. You need to order these separately.
4
Installation
SAFETY INSTRUCTIONS FOR INSTALLATION
•
Install the appliance with two people.
•
Wear safety gloves. The appliance has sharp edges.
•
The distance between the lowest point of the appliance and a gas hob must be a minimum of 75 cm. For an
electrical, ceramic or induction hob, the minimum distance must be 65 cm.
•
Always obey the manual of the cooker or the gas hob if that manual states a larger distance.
•
Warning:
•
Risk of electric shock
•
Always use the screws or fasteners that are stated in the installation instructions. Failure to do so
can result in electric shock.
28
•
English
D
Speed button 3
E
Lamp button
Function
To stop the appliance.
To start the appliance at the lowest speed.
To start the appliance at the middle speed.
To start the appliance at the highest speed.
To activate/deactivate the lamps.