Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
WATER DISPENSING
• Place the device on a flat, stable surface, in a place where it cannot fall over.
• Remove the water tank cover
at least above the "MIN" mark and not above the "MAX" mark on the water gauge . .
• DO NOT fill in water with temperature over 40
• There are holes in the tank above the "MAX" indication mark, which will release water in case of overfilling and
avoid vacuum from being created in the tank compartment.
• Close the water tank by placing the water tank cover
• Place your cup on the removable drip tray
• Press the power ON/OFF button
200 ml of hot water. Once finished the device switches off automatically.
• Press the power ON/OFF button
dispense hot water continuously. Once the desired volume has been reached, press the power ON/OFF button
to stop the device from dispensing, after which it will switch off automatically.
• When the water tank is out of water, the power ON/OFF button
30seconds, indicating you need to refill the water tank
• Caution: Prevent burns. Do not touch the hot boiling water; it is very hot.
• If you are not going to continue using the device, remove the plug from the power socket.
Thermostat
The device features a built-in thermostat that automatically shuts OFF the device in case of overheating or abnormal
operation. If the device becomes too hot (overheating), the thermostat and fuse will activate and stop the device
from working. Let it cool down for approximately 30 minutes and the fuse will reset automatically.
The device can be used again.
In case the device does not operate normally after it has cooled down, it is recommended to reset the thermostat
fuse manually by pushing the reset button key B in the small reset buttonhole A , until you hear a click. Please use
the reset button key B for this action.
Drainage stopper
In case the device will not be used for a long period of time, clean it and remove the wastewater.
Open the drainage stopper C by turning it counter-clockwise, so the wastewater can flow out. Once all the
wastewater has been removed, place the drainage stopper C back by turning it clockwise and make sure it tightens
well.
Note! In case of any water leakage after filling the water tank, check that the drainage stopper is properly tightened.
and fill the water tank
.
℃
and make sure it aligns with the spout
, which lights up blue. After ± 5 to 10 seconds the device starts to dispense
twice, which lights up green. After ± 5 to 10 seconds the device starts to
with clean water. Make sure the water tank is filled
back on the water tank
flashes blue and green alternately for ±
.
6
.
.
EN
Advertenties
Inhoudsopgave
