Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Pool Layout with Solar Heater
Typical above-ground pool
layout
Under the main base, there are two holes for hose connector assembly; one is located in the center and
another one is on the side. Water flows in the heater coils from the center hose connector and then out through
the side hose connector back to the pool. Longer hose is provided for the connection of the heater to the
pump/filter, and short hose is provided for connection of additional heater as shown. If the length of hoses
provided does not fit your pools, you can use another soft hose with same diameter.
Hose Connectors on the Main Base
Two hose connectors are preinstalled on the bottom of the main base. Center hose connector is for hose
connection to the pump/filter. Side hose connector is for hose connection to the pool return or additional solar
heater.
Before connecting to the hose, turn the side hose connector anticlockwise as shown until it stops. The
openings of 2 hose connectors should point in opposite directions.
With one Solar Heater
With multiple Solar Heaters
17
Advertenties
Inhoudsopgave
Probleemoplossen
