Advertenties
Beschikbare talen
Beschikbare talen
Attention: Please read the following instructions carefully to ensure that mounting operation will be carried out
in the right way .These instructions should be properly preserved for future reference.
Ⅰ.Main construction Data
Type:
Rated
Supply
Power:
Current
1524228
100W
Max.
455mA
Ⅱ.Safety instructions
1. Before mounting and maintenance please make sure that the electrical supply has been switched off to
avoid electric shock.
2. The lamp must be earthed.
3. The power cord should be VDE-certified H05RN 3x1.0mm
4. The external flexible cable or cord of this luminaire cannot be replaced. If the cord is damaged, the
luminaire shall be destroyed.
5.Terminal block not included.Installation must be performed by a qualified person.
6.To reduce the risk of strangulation the flexible wiring connected to this luminaire shall be effectively fixed to
the wall if the wiring is within arm's reach.
Ⅲ. Assembly
1.Turn off the power.(see Fig 01)
2.Loosen the screws on the mounting bracket with a tool and remove the mounting bracket.(see Fig 02.1)
3. Determine the installation location and mark the wall. (see Fig 02.2)
4. Drill holes with an electric drill at the marked locations.(see Fig 02.3)
5.Install the plastic expansion into the wall mounting hole.(see Fig 02.4)
6.Use the tool to fasten the screws, flat washers and fixing bracket to the mounting holes.(see Fig 02.5)
7.Use a tool to fix the screw, flat washer and lamp body onto the bracket, and do not lock them too tightly.(see
Fig 02.6)
8. The plug is connected to the power socket.(see Fig 02.7)
9.Adjust the lighting angle of the lamp, and use tools to lock the screws on the holder.(see Fig 02.8)
10. Switch on the power for use.(see Fig.03)
Ⅳ.Operation
1. The lamp is suitable for mounting on the wall.The installation height must be less than 3m.(see Fig. 03)
2. The lamp can be tilted down 90
CAUTION:
The light source of this luminaire is not replaceable, when the light source reaches its end of life the whole
luminaire shall be replaced.
This marking indicates that this product should not be
disposed with other household wastes throughout the EU. To
prevent possible harm to the environment or human health
from uncontrolled waste disposal, recycle it responsibly to
promote the sustainable reuse of material resources. To return
your used device, please use the return and collection systems
or contact the retailer where the product was purchased. They
can take this product for environmental safe recycling.
EN | LED Floodlight Instruction
Power
protective shield
factor
＞0.9
260*198*5mm
and upward 80
.(see Fig.03)
0
0
Weight
Maximum
Dimensions
projected
area
2.11kg
582cm
2
280*75*208mm
2
waterproof cable.
Remark:
Advertenties
