Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Controls
1: Power level higher (+)
2: On/Off motor
3: Power level lower (-)
4: On/off lighting
5: Led
Note: the LED on the hood indicates the various
speeds: green 1st speed, orange 2nd speed, red
3rd speed and flashing red 4th speed. All hoods
with capacities exceeding 650 m3/h have the last
timed speed; It lasts for 7 minutes, after which it
automatically returns to the last non-timed speed.
Initialization procedure:
1. Cut off power to the hood
2. Power the hood again
3.Within the first 5 sec, press the light button and release it after the lights turn on
(the control must be turned on via key 3)
4. Within 5 sec, press the motor key and release it
Now you have to wait for about 10 seconds – then you can use the hood normally.
Notes: after 4 hours from the last use of a key, the hood turns off automatically.
Should there be interferences with other nearby remote controls, carry out the
code change procedure. Should it be required to replace the radio control, the fre-
quency of the electronic system of the new radio control must be calibrated again
via the initialization procedure.
Procedure for generating a new code for the radio control:
The radio control is supplied with default codes. If you want to generate new
random codes you need to follow the procedure below: simultaneously press the
plus and minus keys for at least 10 seconds; the LED will turn on, then press the
two buttons again (within 3 seconds). The LED flashes three times to indicate that
the operation has been completed. Once you changed the radio control you must
run again the initialization procedure.
20
Advertenties
Inhoudsopgave
