Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
D. Operation Instruction
1. Before using, check whether the power supply installation is regular to make sure
the supplied voltage is coordinated with the using one.
2. Put the plug in the socket and turn on the power.
3. Turn the temperature controller clockwise to the temperature needed. The yellow
indicator is on that shows heating wire begins to heat and the upper and lower
griddle begins to raise temperature.
4. Temperature can be adjusted according to different food preferably within
180 °C ~ 250 °C. About 8 minutes is needed for the temperature to be raised to
250 °C from the power is on.
5. When the temperature reaches 250 °C, lift the upper module plate to a suitable
place by operation handle. Put some edible vegetable oil on the lower module plate
and constantly place the food on it. Close the plates and press the handle lightly.
Keep an eye on the food until it is suitably done.
6. When temperature reaches the setting degree, temperature controller can cut off
power supply automatically. At the same time, yellow indicator is off and green
indicator is on. It shows that electricity heating tube stops working for next turn.
7. At the lower front of the lower module is the oil tray. Substantial vegetable oil and
the animal oil from the meat grilled flow to the oil tray from the lower module plate.
8. Lift the upper module plate to take the sandwich and other food already done.
9. When the temperature is a bit lower, the temperature controller can get through
power supply automatically. The heating tubes restart to work to heat the module
plates.
10. On completion of the work, temperature controller should be turned to the "off"
place. Unplug the equipment and cut off the power.
11. Notice: There is temperature limiter in the bottom box, the action temperature is
130 °C, and reset temperature is <40 °C. When temperature is over the protective
button works for protection. When use it again, please use it after press the
protective button.
E. Cleaning and Maintenance
1. Cut off the power supply before cleaning in case of accident.
2. Do not use wet towel with non-corrosive cleanser to clean the module plate, the
surface of the equipment and power cord. Direct wash by water is not permitted in
case of any damage of the functions.
3. If do not use it at any time, please turn off temperature controller and main switch.
4. Please store the equipment in a ventilated storehouse without corrosive gas after
cleaning when ceasing its work for a long time.
688400-405-410-415-420-25 M20NE
-10-
Advertenties
Inhoudsopgave
