Before operating your new safe, please read the user manual to ensure maximum ease
of operation.
Installing the batteries
The safe is unlocked after leaving the factory.
Open the door and remove the battery cover on
the back of the door and install 4x AA 1,5 V
batteries. Ensure the batteries are fitted with the
correct corresponding polarity.
We recommend you use Duracell alkaline
batteries.
Programming the code
The safe is equipped with a master code with factory preset 011223. It is strongly
recommended to change the codes before using the safe.
How to program the master code?
Door position: open and unlocked.
* *
1.
Press
2.
Enter the master code, the display will show "-NEW--". The master code preset is
011223.
3.
Enter your new 6 digit master code within 5 seconds, display will show "AGAIN-"
4.
Repeat the new master code within 5 seconds. If the display shows "-DONE-" the
new master code is programmed successfully.
Remark:
•
Verify the new master code 3 times with the safe door opened.
How to close the safe?
1.
Close the door and keep the door shut
2.
Enter your PIN code (minimum 3, maximum 6 digits)
3.
Press
#
4.
The locking bolts wil lock the door automatically and display will show "CLOSEd"
E.g. for PIN code 2442
Version 2.1 – October 2021
the lock will enter the program mode, display will show "-PROG--"
2 4 4 2 #
Battery cover
3