Download Inhoudsopgave Inhoud Print deze pagina

Cleaning And Maintenance; Error Codes - CaterChef 688018 Series Gebruiksaanwijzing

Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

CLEANING AND MAINTENANCE:

Step 1: After usage, the device must first be switched OFF, after which you must remove the
plug from the socket. Always do this in the order described to prevent short circuit
or other possible dangers.
Step 2: Wait until the device has cooled down completely.
Step 3: Push on the black cap of the tap and turn it a quarter to let the oil run out of the
basin.
Step 4: Remove the grid (nr. 3).
Step 5: Clean the in- and outside of the device with a wet cloth and a small amount of
cleaning-detergent and then dry it thoroughly. Do not use benzine, thinner, scouring
brush or polishing powder to clean the induction fryer.
Š Pay attention! Do not rinse the device with water. (Don't wash it by using the tap).
This could cause damage to the device and could therefore lead to dangerous
situations.
Š Never clean the device with a stainless steel brush.
This causes scratches and damages the device.
Š Use a vacuum cleaner to (gently) remove dirt and debris from the air-ventilation-grille.
Š Always store the fryer inside and keep it dry.

ERROR CODES

Display information
for control panel
HEATING light
flashing once
(again and again)
HEATING light
flashing 2 times
(again and again)
HEATING light
flashing 3 times
repeatedly
HEATING light
flashing 4 times
repeatedly
688018-218 en-nl ma 2020
Description
Possible cause
Check ventilation
Insulated Gate Bi-
slots on dirt
polar Transistor on
and grease
the Printed Circuit
and make sure
Board Is overhea-
there is enough
ted. Buzzer alarms.
space around the
appliance.
Heating without oil
No oil in the tank.
in the tank.
Electrical
Voltage higher than
installation could
265V, lower than
be disordered or
135V
damaged.
Temperature sensor
in the oil tank is
Temperature sensor
either shorted or
is defective
opened. Buzzer
alarms
Possible solution
Switch the appliance OFF,
let it cool DOWN. |
Switch appliance on again.
Contact your supplier if it happens
frequently.
Fill the tank with oil.
Make sure an electrician will check it.
Appliance IS overheated. Let it cool
down. Contact your supplier if it happens
frequently.
12

Advertenties

Inhoudsopgave
loading

Deze handleiding is ook geschikt voor:

688218

Inhoudsopgave