Advertenties
Beschikbare talen
Beschikbare talen
5.
Remove the PVC sleeve on the shaft. Insert the ventilation blade
into the shaft. Make sure the stopper pin is clipped in to the groove
of the blade. Screw the spinner counter clockwise tot tighten the
blades.
(FIGURE 2)
6. Hold the front guard to make sure that the trademark is level and
that the front guard are centred over the rear guard. Then push all
the safety clips into their places. (FIGURE 3)
OPERATION INSTRUCTIONS
FAN SPEED CONTROLL (ON/OFF & SPEED)
Use the speed switches to switch the fan on and off. Press the switch to turn
on the required speed. The fan has four speed positions: 0 = off,
= medium, 3 = high (FIGURE 4)
OSCILLATION CONTROL
To make the fan move (oscillation function) press the oscillation button. This
button is located at the top of the motor housing. To move the air flow, press
the oscillation button. You can click the oscillation button to move the fan to
the required position. (FIGURE 5)
TILT CONTROL
Unscrew the till knob, adjust the fan head to the desired angle by holding
the fan head, then tighten the knob (FIGURE 6)
1 = low, 2
Advertenties
