WARNING! The appliance must not touch any pipes for
heating, gas or water supply or any other electrical
devices.
Do not cover the ventilation holes at the top of the appliances–it must be a good air
circulation around the appliance. There should be a gap of at least 10 cm between
the top of the appliance body and any furniture that may be above it.
clockwise – the front of the appliance rises, by turning them counter clockwise – it
comes down. If the appliance is tilted slightly backward – the doors will close by
themselves.
Temperature set in the freezer by the manufacturer is -18
The temperature in the appliance is controlled using the thermostat knob 1 (fig. 1) by
turning it to one side or the other. The temperature indication in digits is shown beside
the thermostat knob.
The temperature is regulated on the scale of seven digits.
0 = Compressor is switched off. W A R N I N G ! Electric current is not switched off.
1 = highest temperature (lowest cooling)
7 = lowest temperature (highest cooling)
Please set the desired temperature in the appliance according to your own
requirements.
THE TEMPERATURE IN THE FREEZER MAY VARY DEPENDING ON AMBIENT
TEMPERATURE, THE AMOUNT OF FOODSTUFFS, THE TEMPERATURE OF THE
FOODSTUFFS, AND HOW OFTEN THE APPLIANCE DOOR IS OPENED AND
CLOSED.
IF THE ROOM IS COOL, THE APPLIANCE COOLS LESS. THE TEMPERATURE IN THE
APPLIANCE MAY THEREFORE RISE. Use the thermostat wheel to set a lower
temperature
.
requirement is not followed, the appliance
consumes more electrical energy and its
compressor may overheat.
If the appliance is placed in a corner, a
gap of at least 6 cm must be left between
the appliance body and the wall so that
the freezer door can be opened enough to
pull out the frozen product drawer (see
fig.).
The appliance must stand on a level
surface and must not touch the wall. If
necessary, regulate the height of the
appliance by adjusting the levelling feet: by turning them
T E M P E R A T U R E R E G U L A T I O N
0
C
8
If this