Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Cheminées - Ventilation - Accumulateurs Thermiques - Traitement de l'eau
keep all the instructions given under all circumstances.
3.1 Advice for user
Avoid positioning any objects and/or appliances that could be damaged by water leaks beneath the
water heater.
Should you not use any water for an extended period of time, you should:
• disconnect the appliance from the electrical supply by switching the external switch"OFF".
• turn off the plumbing circuit taps.
• hot water at above 50°C flowing out of the taps at the point of use could cause serious scalds or even
death from burns. Children, the disabled and the elderly are more exposed to the risk of burns. It is
strictly forbidden for the user to perform any routine or extraordinary maintenance.
3.2 Starting
To turn on the appliance is enough to put into"ON" position the bipolar switch (see electrical
connection)
3.3 Temperature adjustment
Models with external thermal regulation are equipped with an adjustment knob situated onto the plastic
cap.
The customer can adjust, as his preference, the temperature in order to get the best pleasure.
We suggest a regulation below the maximal set in order to achieve the best performance with o good
level of efficiency and good comfort. Models with no thermostat control knobs have automatic water
temperature preset by the Manufacturer 65°C +/- 5°C
4. MAINTENANCE INSTRUCTION (for competent persons)
WARNING. Follow the general warnings and the safety norms listed at the beginning of the text and
keep all the instructions given under all circumstances.
Before execute any type of operation (maintenance, cleaning,...) switch off the appliance.
All intervention must be performed by qualified personnel only. For operation on thermostat
remove the plastic cap after electrical disconnection. For operation on resistance drain completely the
appliance (see respective paragraph).
4.1 Periodic maintenance
In order to obtain the best performance from the appliance is advisable to descale the resistance every
year. The operation can be carried out crumbling the limescale from the cover of the resistance. Take
care to not damage it.
The magnesium anode must be substitute every 2 years (see warrantee conditions). In order to remove it
is necessary to remove the resistance. The pressure-relief device is to be operated regularly to
remove lime deposits and to verify that it is not blocked.
4.2 Draining of the appliance
In order to drain the appliance proceed as follow:
1. Switch off the electrical connection
2. Turn on the tap of inlet cold water
3. Turn on the tap of hot water
4. Turn on the drain tap if equipped during installation, otherwise remove the safety valve for undersink
models is necessary to overturn the appliance.
4.3 Bipolar safety reactivation
The appliance is equipped with a thermostat with safety limiting device according to IEC-EN
regulations. In case of abnormal overheating of the water, a thermal safety switch shuts off the
11
www.detandt.com
Advertenties
Inhoudsopgave
