Advertenties
CARE OF TRACTOR
1.
Keep tractor greased and oiled regularly. Re-
fer to Figure 1 for the location of grease fittings. Check
transmission and engine case oil levels.
2.
Keep engine air cleaner clean . . This will add
to engine life.
3.
Keep ti res properly inflated., See previous in-
structions"
4.
Keep tractor covered and in a dry place when
not in use,.
5.
Keep grass and dirt out of engine cowling as
these will stop the flow of air and decrease en·
gine life.
6.
BRAKE ADJUSTMENT. The brake band, located
on the left side of the transmission, brakes the trans-
mission and in turn stops the wheels.
To adjust, depress clutch brake pedal and move
parking brake lever forward into the engaged posi"
tion. Tighten nut on brake rod until both rear wheels
skid when tractor is pushed -
parking brake en ..
gaged. Tighten nut another
Y2
turn. The brake and
parking brake are now properly adjusted.
7.
CLUTCH·BRAKE
PEDAL
ADJUSTMENT.
The
clutch-brake pedal rod may be turned in or out to
adjust the pedal to operator's desired position. Re·
move pin from rod and turn rod in or out for adjust-
ment. There are also two holes in the pedal to adjust
for travel. The upper hole is for a short movement
of travel, the lower hole is for a long movement.
8.
When replacing belts or mounting drive im-
plements make sure all pulleys are in line.
9.
BATTERY"
Check electrolyte level periodically.,
If tractor has been in storage it may be necessary to
recharge"
10.
Your tractor is only as good as the service
you give it. See your Wheel Horse Dealer for a
thorough check.up after each season of use.
11.
When replacing belts be sure to purchase gen ..
uine Wheel Horse belts, as these belts are specifically
designed for each application.
(NOTE: Make sure all pulleys are in line.)
12.
To raise seat/fender unit pull knob back. See
Fig. I. Seat should be latched before operating tractor.
SAFETY SUGGESTIONS
Recommended by Outdoor Power Equipment Institute
1.
Know the controls and how to stop quickly
read the owners manual.
2.
Do not allow children to operate machine; nor
adults to operate it without proper instruction.
3.
Clear work area of objects which might be
picked up and thrown.
4.
Disengage all clutches and shift into neutral
before starting motor. Keep hands, feet, and clothing
away from power driven parts.
5.
Do not carry passengers. Keep children and
pets a safe distance away.
6.
Never direct discharge of any material toward
bystanders, nor allow anyone near machine while
in operation.
7.
Disengage power to attachment (s) and stop
motor before leaving operator position.
8.
Take precautions when leaving machine un·
attended (to avoid accidental starting, rolling away,
accidental dropping of any attachment, etc.,)
9
Disengage power to any attachment when"
ever it is not in use, or when traveling from one
work area to another . .
3
10.
Stay alert for holes and other hidden hazards.
Know what is behind you, before backing up.
11.
Beware of steep slopes; reduce speed on all
side slopes and sharp turns, to prevent tipping or
losing control.
12
Don't stop or start suddenly when going uphill
or downhill"
13.
Use care when pulling loads or using heavy
equipment,
14
Watch out for traffic when near roadways.
15.
Handle gasoline with
care -
it is
highly
flammable.
a.
Use approved gasoline container.
b. Never add gasoline to a running motor
fill tank out of doors and wipe up spilled
gasoline.
c.
Replace gasoline cap securely.
d. Open doors if motor is run in garage -
exhaust gases are dangerous.
16.
Keep machine in good operating condition and
keep safety devices in place. Use guards as instructed
in owner's manual.
RF.GUlATOR _ _
COIL
SI'lORK
PLUG
KOHLER
GROUND
lIGMfU
IGNI110N . HAtHt
~WITCH
WIRING DIAGRAM
SPECIFICATIONS
(Specifications subject to change withoul noticeJ
length Overall
Wheelbase
Width Overall
Width at Front Wheels
Height
Height to Tap of Hood
Approx. Shipping Weight
Crap Clearance
Frame Clea ra nee
Engine (4.cycie, single cylinder, air cooled)
Horsepower (Manufacturer's Rating)
Engine Oil Capacity
Fuel Capacity
Transmission Oil Capacity
Tires (front) 550·8 Pneumatic
(J
6" wheel dia.)
Tires (rear) Terra-Type 8.50 x 12" Pneumatic (23" wheel
Speeds -
3 Forward to 6 mph
1 Reverse to 2)1 mph
Turning radius (to outside of outside wheel)
61 inches
41
~
inches
35 inches
33)1 inches
37)1 inches
33)1 inches
... , 430 Ibs.
7~
inches
13)/2 inches
Electric Start
8 H . . P,
2)1 pints
6 quarts
2 quarts
dia.)
6'
Advertenties
