Inhoudsopgave
Advertenties
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
disposed of at a designated collection point. This can
occur, for example, by handing it in at an authorised
collecting point for the recycling of waste electrical
and electronic equipment.
13. Troubleshooting
Fault
Device does not work
The motor starts but there is
no build up of pressure
Irregular operating pressure
Cause
No electrical voltage at the device.
Cross section of the extension cable
not large enough and/or the exten-
sion cable is too long.
The mains voltage is lower than that
specified.
The pump is frozen.
Air intake in the water inlet.
Discharge nozzle is too large.
Air intake in the water inlet.
www.scheppach.com
Improper handling of waste equipment may have
negative consequences for the environment and hu-
man health due to potentially hazardous substances
that are often contained in electrical and electronic
equipment. By properly disposing of this product, you
are also contributing to the effective use of natu-
ral resources. You can obtain information on collec-
tion points for waste equipment from your municipal
administration, public waste disposal authority, an
authorised body for the disposal of waste electri-
cal and electronic equipment or your waste disposal
company.
Remedy
Check the fuse, power cable and power
plug and have them replaced by qualified
personnel if necessary.
Use extension cables with larger cross
sections and/or use shorter extension
cables.
Contact the power supply company if
necessary.
Check and thaw if necessary.
Check the supply hose and hose connec-
tion and replace if necessary.
Check and replace if necessary.
Check the supply hose and hose connec-
tion and replace if necessary.
GB | 23
Advertenties
Hoofdstukken
Inhoudsopgave
