Download Inhoudsopgave Inhoud Print deze pagina

Assemble The Shaft; Attach The Auxiliary Handle; Install The Battery Pack; Remove The Battery Pack - GreenWorks G24LT25 Gebruiksaanwijzing

Inhoudsopgave

Advertenties

3.4

ASSEMBLE THE SHAFT

Figure 4.
WARNING
Never install, remove, or adjust any part of a machine while
the battery is installed in the machine or the machine is
running.
When you remove the machine from the box, the three
poles of the machine are connected by an electrical cord as
shown.
1. Push in the release button located on the middle shaft.
2. Align the release button with the positioning hole on the
upper shaft and slide the two shafts together until the
button locks into the positioning hole.
3. Repeat above procedure to connect middle shaft to lower
shaft.
3.5
ATTACH THE AUXILIARY
HANDLE
Figure 5 - 6.
1. Remove the knob from the handle.
2. Attach the auxiliary handle on the shaft.
3. Set the auxiliary handle in the comfortable position.
4. Tighten the auxiliary handle with the knob.
3.6

INSTALL THE BATTERY PACK

Figure 7.
WARNING
If the battery pack or charger is damaged, replace the
battery pack or the charger.
Stop the machine and wait until the motor stops before
you install or remove the battery pack.
Read, know, and follow the instructions in the battery
and charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.7

REMOVE THE BATTERY PACK

Figure 7.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
NOTE
English
4

OPERATION

Before you operate the machine, read and understand the
safety regulations and the operation instructions.
Be careful when you operate the machine.
4.1

START THE MACHINE

Figure 8.
1. Pull back on the lock-out button and pull the trigger.
4.2

STOP THE MACHINE

Figure 8.
1. Release the trigger to stop the machine.
4.3
ADJUST THE LENGTH OF THE
CUTTING LINE
Figure 8.
The machine has an auto-feed head. It will damage the
machine if you hit the head to try to advance the line.
If the cutting line does not automatically advance, it can be
tangled or empty.
1. When the machine is on, release the trigger.
2. Wait two seconds, push the trigger again.
The line will extend approximately 0.4 in. with each stop
and start of the switch trigger until the line reaches the cut-
off blade and the cut-off blade cuts the excess length.
4.4

OPERATION TIPS

Figure 9.
Keep clearance between the body and the machine.
Do not operate the machine without guard in place.
Do these tips when you use the machine
Keep the machine connected to the correctly worn
harness.
5
IMPORTANT
WARNING
NOTE
NOTE
NOTE
WARNING
WARNING
EN

Advertenties

Inhoudsopgave
loading

Deze handleiding is ook geschikt voor:

Stg308

Inhoudsopgave