Advertenties
5. Description of the DIP switches and status LEDs
5.1 DIP switches
Number
Function
1
Master (CPE) / Slave (CO)
2
Transmission
3
Transmission rate
4
Signal-to-noise-ratio
DIP 1: Master / Slave
ON position
Control device
OFF position
End device
DIP 2: Transmission
ON position
Fast mode
OFF position
Interleave mode
DIP 3: Transmission rate
ON position
Unlimited
OFF position
Limited
DIP 4: Signal-to-noise-ratio (SNR)
6 dB
ON position
OFF position
9 dB
All manuals and user guides at all-guides.com
ON position
Control unit (Master)
Fast mode
Unlimited
6 dB
Use this switch position to connect the device to a PC or a
router which accesses the network camera on the slave side.
Select this switch position to use the device on the network
camera.
Use this setting to establish a fast data connection. Please
observe that data loss could occur using this setting.
Use this setting if there is a high data rate, and thereby avoid
any data loss on the transmission range.
Use this setting to utilise a maximum data connection with a
transmission rate of up to 100 MB/s download/60 MB/s upload.
Use this setting in the event that data losses occur on the
transmission line. The transmission rate is then decreased to
50 MB/s download / 30 MB/s upload in order to reduce the
data loss.
Standard noise reduction which is used to compensate
interference on the line.
Increased noise reduction; the signal-to-noise ratio is
increased in this mode. This will be necessary in the event that
increased data loss occurs on the wiring section. The
maximum transmission path is then reduced in this mode.
19
English
OFF position
End device (Slave)
Interleave mode
Limited
9 dB
Advertenties
Hoofdstukken
