Advertenties
Assembly and dismantling
Place all parts on the floor in front of you and check whether all listed parts are present in the specified number. Please contact the manufacturer
immediately if parts are missing or damaged. After assembly has been completed or started, complaints due to damage or missing parts can no longer
be accepted!
Make sure that the rods engage correctly.
1. Plug the rods (3+4) and the corner connectors (9) together as shown in figure "1".
2. Plug the roof bars (1+2) and the roof connector (8) together. Then plug it into the corner connectors (9) as shown in figure "2".
3. Tension the roof cover (12) over the fully assembled roof frame. Make sure that it is taut. Fasten the roof cover (12) to the roof frame with the Velcro
fasteners.
4. Now carefully lift the complete roof frame with roof cover (12) with at least 2 persons and join the corner connectors (9) with the rods (5) as shown in
figure "3".
5. Put the bottom plates (10) on the lower end of the rods (6). Put the other end of the bar (6) on the bar (5), Attach the roof cover (12) to the bars (6)
with the hooks as shown in the figure "4".
6. Verankern Sie das Zelt an den Bodenplatten (10) mit den Heringen (7). Befestigen Sie die Abspannseile (11) an den dafür vorgesehenen Ecken des
Dachbezuges (12) und spannen Sie diese mit den Heringen (7), wie auf der Abbildung „5" zu sehen.
When dismantling the tent, please proceed in reverse order to erecting it.
Cleaning and care instructions
Use a cotton cloth and clear water for cleaning. For stubborn dirt, we recommend lukewarm water and a mild detergent. Never use petrol, solvents,
scouring agents or chlorine-based cleaning agents. Spilled liquids should be removed immediately. Use only recommended care products for mainte-
nance.
Operating instructions
Safety information
Care instructions
10
Advertenties
