Inhoudsopgave
Advertenties
CLEANING
AND
MAINTENANCE
PRECAUTION
INSTRUCTIONS
-
IMPORTANT: Before carrying out the
cleaning
and
disconnect the equipment from the mains
power supply.
-
High temperatures can be reached inside
the machine (90°C). After power supply has
been removed, wait until the machine has
reached room temperature, before working
on it.
-
The machine protection degree is IP21,
therefore it should not be washed with
direct high-pressure jets of water.
-
never leave tools, parts or other loose
material on the machine or inside of it.
BEFORE starting machine or cycle, after
-
any maintenance or repair work, make sure
all protective are correctly installed.
POSSIBLE TROUBLES - CAUSES - SOLUTIONS
PROBLEMS
The machine doesn't catch
The water doesn't go in
Insufficient Washing
Insufficient Rinsing
The lamp "E" is flashing
PREVENTIVE
AND
CLEANING
maintenance
operations,
CAUSES
Main switch is switched off
Water cock closed
The Overflow is not in place
Wrong detergent or insufficient
dosage
Low temperature in the tank
Dirty wash filter
Rinsing nozzles blocked
Hydraulic pressure lower than
1 bar - 100 kPa
Salt exhausted
quickly
CAUTION! FOR ANY OTHER TROUBLE, CALL SERVICE
DAILY MAINTENANCE
-
Disconnect the machine with pushbutton
"A";
-
Lift the overflow pipe and let the water
drain out of the tank;
-
Wash thoroughly the
housings to remove all impurities;
-
Take the filters out and clean them under
running water;
-
Re-assemble the overflow pipe and the
filters in their housings;
-
Check and clean the washing and the
rinsing jets;
-
Clean the outer surface of the machine by
using a wet sponge; do not use water jets
because, besides being dangerous, they
could damage the electrical parts; do not
use abrasive detergents;
-
When the machine is to remain idle for a
long time, drain all the water from
boiler and
Also leave the door open.
NEVER WASH THE EXTERNAL PART
THE MACHINE WITH A WATER JET
SOLUTIONS
Turn ON the main switch
Open water cock
Reassemble the Overflow in
place
Use anti-foam detergent in the
right dosage and never with
cold water
Wait until the water gets hot
Clean filter
Unscrew and clean nozzles
under running water
Wait until the pressure is on or
buy a booster pump
A
dd salt in the container
(see page 22)
23
tank and the filter
from the
electro
pump.
the
OF
Advertenties
Inhoudsopgave
