Manual_FX-RM5170AGILE_Int24_rev1
To stop the engine, release the throttle!
16. Assembly
Essential instructions for assembling the mower
Before assembling and operating the petrol lawnmower, please read the full user manual and the
instructions.
IMPORTANT INFORMATION: The lawnmower is supplied WITHOUT FUEL AND OIL in the engine.
Your new lawnmower has been tested in the production facility, i.e. there may be a small amount of
residual oil in the engine or visible on the dipstick!
TAKE THE LAWNMOWER OUT OF THE CARDBOARD BOX
Remove the lawnmower from the cardboard packaging and check that no loose parts remain in the
packaging.
Assembly upper and lower tie bar
Carefully unfold the lawnmower handle, not pinching or damaging the lawnmower control cables.
Open the handle and tighten the handle parts with the four wing nuts, one washer each and the
screws, as shown below. Insert the starter cable on the right side of the handle and secure it with the
plastic handle (see the following pictures).
If you want to adjust the handlebar height, you can choose the two holes "L" or "H" in the left and
right bracket to fix the handlebar with screws and buttons.
The "H" hole is the high position of the handlebar, and the "L" hole is the low position of the
handlebar.
40