Inhoudsopgave
Advertenties
6. Standard equipment
Item
Designation
A
Basic unit
B
Upper part of grass catcher
box
C
Lower part of grass catcher
box
D
Pin
N
Safety plug
O
Battery
P
Charger
–
Instruction manual
MA 443:
E
Quick-clamping device
F
Bolt
G
Cable guide
H
Cable clip
I
Protective sleeve
MA 443 C:
J
Sleeve
K
Bolt
L
Washer
M
Nut
The standard equipment may vary
depending on the country and
version type.
0478 131 9922 D - EN
7. Preparing the machine for
operation
2
7.1 General
Qty.
Risk of injury!
1
Observe the safety instructions in
1
the section "For your safety" (
Remove the safety plug,
1
particularly before
performing any work on the lawn
2
mower (
9.1).
1
● Place the machine on level and firm
ground when performing all the
operations described.
1
Upon delivery, the batteries are
charged to approx. 30%. They must
be therefore be charged before
2
being used for the first time.
2
● Charge battery (
1
1
2
7.2 Installing mono handlebar
(MA 443 C)
1
● Insert the sleeve (J) in the bore
1
on the handlebar (1).
2
● Fit the two washers (L) with the convex
1
side facing inwards onto the sleeve in
the handlebar (1).
● Hold the sleeve (J) and washers (L)
and insert together with the
handlebar (1) into the holder on the
handlebar console (2).
● Insert the bolt (K) from the outside
inwards through the bores in the
handlebar (1) and in the handlebar
console (2). Screw on the nut (M) and
tighten the bolt (K).
Tightening torque:
15 - 20 Nm
Installing the electric cable:
● Insert the electric cable (3) in the
4.).
holders (4) of the strain relief moulding
on the handlebar console as shown.
7.3 Installing dual handlebar
(MA 443)
● Fit the protective sleeves (I) onto
the lower handlebars (1).
● Insert the screw (F) through the bore in
the cable guide (G).
● Fit the upper handlebar (2) onto the
lower handlebar sections (1).
8.4).
● Attach the cable guide (G) to the
electric cable (3) and insert the
screw (F) through the bore from the
inside outwards.
3
● On the opposite side, insert the
screw (F) from the inside outwards
through the bores.
● Screw the quick clamping devices (E)
onto the screws (F) (the screw should
project by about one screw thread turn)
and fold upwards.
4
41
Advertenties
Hoofdstukken
Inhoudsopgave
