Inhoudsopgave
Advertenties
How to Load Smart Materials
1. Position material under material
2. Hold against rollers as you press
guides.
the flashing Load/Unload button.
How to load machine mat with material
1. Remove plastic cover, then align
2. When prompted, insert mat
material onto mat. For fabric, use
under material guides.
brayer to smooth down.
How to change tool
1. Open Clamp B and remove tool.
2. Firmly seat new tool. If relevant,
use gears to align.
6
™
3. Hold mat against rollers as you
press flashing Load/Unload button.
3. Close clamp.
Important safety instructions
PLEASE READ THIS ENTIRE DOCUMENT PRIOR TO
SETTING UP, OPERATING AND SERVICING YOUR
CRICUT® SMART CUTTING MACHINE. PLEASE
FOLLOW THE ENCLOSED INSTRUCTIONS, ONLINE
INSTRUCTIONS AND OTHER OFFICIAL CRICUT
INSTRUCTIONAL MATERIALS. FOR MORE SAFETY
AND COMPLIANCE INFORMATION, GO TO CRICUT.
COM/SAFETY.
In these instructions the term "Machine" means
Cricut Maker™ 3.
WARNING: Risk of Injury, Fire and Electric
Shock.
Operating Machine in a manner not
prescribed in the enclosed instructions, online
instructions and other official Cricut materials may
result in damage to the Machine, property damage,
injury or even death.
Machine is only intended to be operated by
an adult. Not intended for use by children
12 years or under. Always supervise children
around Machine.
Only use Machine for its intended crafting purpose.
Indoor Use Only. Machine is only intended for
indoor use in dry locations. Do not use
in or near water. Do not immerse in water or any
other liquid.
Machine is not intended for use by persons with
reduced physical, sensory or cognitive capabilities,
or lack of experience and knowledge, unless they
are supervised by a person responsible for their
safety and familiar with the safe operation of
Machine.
Disconnect the electrical power by unplugging
machine when not in use and before any servicing
or cleaning.
Only clean Machine with a soft cloth dampened
with glass cleaner or water. Never use any kind
of flammable liquid to clean Machine. Do not use
solvents such as acetone or nail polish remover to
clean Machine as these will permanently damage
Machine's surfaces.
Always unplug Machine before replacing the cutting
blade. Blades are extremely sharp and should be
handled with caution and extreme care. Prevent
blade contact with hands and body to avoid injury.
Do not allow children to handle blades. Blades and
other small parts are choking hazards and should be
kept and stored away from children.
Do not open, modify or otherwise tamper with
Machine.
Do not operate if Machine or cord is damaged.
Contact Cricut Member Care for service: cricut.
com/contact or 1-877-727-4288.
Only use Cricut-approved power adapters.
Always turn Machine OFF before unplugging from
the electrical outlet. Never pull on the cord to
disconnect Machine from the electrical outlet;
instead, grasp the plug and pull to disconnect
Machine.
The power cord should be positioned so that it
will not drape over the countertop or tabletop
where it can be tripped over, snagged or pulled on
unintentionally (especially by children).
Place Machine on a strong, flat, level and stable
surface. Make sure your work space has enough
space in the front and back of Machine to allow the
cutting mat to move through Machine freely.
Do not place your fingers or other objects in Machine
while connected to electrical power or while Machine
is powered on, or during cutting operations.
EN
7
Advertenties
Inhoudsopgave
