Inhoudsopgave
Advertenties
WARRANTY AND AFTER-SALE SERVICES
Warranty
Warranty service as stated on the warranty card
The manufacturer shall not be held liable for any damage caused by improper use of the product.
DOOR REVERSAL
The door of the refrigerator can be opened both from the left or right as required. The following are the
steps required to position the door to open to the right.
Remove the lower bracket (1) on the right, the door and the screw hole cover (4). Remove the lower
bracket pivot (3) and the spring washer (2), and then place and fix them in the hole on the left of the lower
bracket. Remove the cover (5) on the upper brackets on both left and right sides; remove the bracket pivot
on the right side and the spring washer and then fix them in the bracket hole. Install the door between
the upper and lower brackets on the left and fasten the lower bracket by tightening the screws. Install the
screw hole cover in the lower bracket hole on the right, and then install the upper bracket covers on the
upper brackets on the left and right. After installation open and close the door to ensure the door operates
correctly. Move the components (7) and (8) with the special tool provided. Remove the screw (9) from the
refrigerator, open the door fully and replace screw (9) in the corresponding opposite position. Remove
and replace component (10), at the corresponding position on the left, with the special tool provided. Fix
component (7) in the corresponding opposite position.
VENTILATION
Level the kitchen cabinet unit with a spirit level and a try square. Level the unit by placing packing mate-
rial underneath if required. A minimum gap of 38mm must be maintained at the back of the appliance for
ventilation. Air inlet A must be at least 200 cm square and air must flow through the panel in the cabinet
plinth. Check that the position of the power socket (1) is correct. Mains voltage where the appliance is to
be used must comply with that shown on the data plate located on the left inside wall of the appliance next
to the vegetable bins. The power supply must be suitably earthed.
INSTALLATION OF THE APPLIANCE
Installation of the appliance should be performed by a qualified installer. The appliance should be placed in
furniture case. Run the mains cable through the unit such that it can be connected to the power supply after
installing the appliance. Remove the cover (6) only if space is restricted. Place the refrigerator into the kitchen
unit. Fix the brackets (1) with screws (2) onto the upper frame when two third of the refrigerator has been inser-
ted. Then insert the refrigerator in completely, ensuring that the gib clamp of the brackets stuck on the horizontal
frame of the kitchen unit. Adjust the position of the refrigerator making a 6mm space between inside wall of the
kitchen unit and external sides of the refrigerators. Fix the brackets to the horizontal frame of the kitchen unit
with screws. Insert the seal in the aperture (approx. 10mm) between the lower front frame and bottom board of
the kitchen. Fix lower brackets (3) to the lower front frame with screws (2). Fix the lower brackets to the bottom
board of the kitchen unit with screws (2). Properly insert seals in the apertures on the left, upper and right sides
of the refrigerator.
83
Advertenties
Inhoudsopgave
