Advertenties
SETTINGS AND OPERATION
Press "Menu" to switch to the Menu.
Slave setting
When display shows "SLAV" it's in slave mode
Factory value setting
When display shows "REST" press "ENTER" to set the unit back into factory settings.
DMX CHANNELS
Channel
Function
1
Dimmer
2
Speed
DMX-512 CONNECTION
If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of the
first unit in a DMX chain. Always connect the output of one unit with the input of the next unit until all units are connected.
If you use a controller with 5 pin DMX connection you will need to use a 5-pin to 3-pin adapter.
At the last fixture, the DMX cable has to be terminated. Solder a 120 Ohm resistor between signal (-) and signal
(+) into a 3-pin XLR connector and plug this into the DMX output of the last fixture in the chain.
DMX address setting.
When display shows "A001" you can set the DMX address.
Press "UP" or "Down" to adjust the value (001 – 512), press "ENTER" to save the
address setting.
Work mode setting.
When display shows G-x (x = mode number 0 - 4)
0 = DMX control
1 = Auto mode
2 = Sound activation 1
Press "UP" and "DOWN" button to adjust, press "ENTER" to save.
Value
Description
000-036
Off
037-072
Flash
073-108
Fade
109-146
Fast On and Slow Off
147-186
Fast Off and Slow On
187-216
Auto mode
217-255
Sound active mode
000-255
Dimmer
000-255
Speed
3 = Sound activation 2
4 = Sound activation 3
CH2 independent dimming
Speed Adjustable by CH2
CH1 is between 0-36
CH1 is between 37-186
9
Advertenties
