Inhoudsopgave
Advertenties
DMX-512 CONNECTION
If you are using a standard DMX controller, you can connect the DMX-output of the controller directly to the DMX-input of the
first unit in a DMX-chain. Always connect the output of one unit with the input of the next unit until all units are connected.
If you use a controller with 5 pin DMX connection you will need to use a 5-pin to 3-pin adapter.
At the last fixture, the DMX cable has to be terminated. Solder a 120 Ohm resistor between signal (-) and signal (+)
into a 3-pin XLR connector and plug this into the DMX output of the last fixture in the chain.
REMOTE
Function
Sets the unit into blackout on or off.
1
Puts the unit into DMX mode
2
Activate the auto show mode for par and light effects.
3
Activate auto show mode for the par.
4
Activate auto show mode for the light effects.
5
Activate sound active mode for par and light effects.
6
Activate sound active mode for par.
7
Activate sound active mode for light effects.
8
Colour change with jump effect (only for par).
9
Colour change with fade effect (only for par).
10
Activate strobe (only for par).
11
Set the speed using '+' and '-' buttons (note: only available in
12
the auto shows, colour change, colour fade and strobe
modes).
Set the sound sensitivity using '+' and '-' for functions 1 to 4.
13
CAUTION! The remote control is supplied with a battery
inserted. An insulating foil between the battery and the battery
contacts prevents the battery from being discharged during
storage. Prior to the first operation remove the foil from the battery
support on the rear side of the remote control. Otherwise operation of
the remote control is not possible.
REPLACING THE FUSE
If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
FIXTURE CLEANING
The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to optimize light output.
Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or particularly dirty surrounding
can cause greater accumulation of dirt on the unit's optics.
•
Make sure the area below the installation place is free from unwanted persons during servicing
•
Housings, fixations and installations spots( ceiling, truss, suspensions) should be totally free from any deformation
•
The mains cables must be in impeccable condition and should be replaced immediately when even a small problem is
detected
•
In order to protect the fixture from overheat the cooling fans (if any) and ventilation openings should be cleaned
monthly.
•
The interior of the fixture should be cleaned annually using a vacuum cleaner or air-jet.
•
Clean with soft cloth using normal glass cleaning fluid.
•
Always dry the parts carefully.
•
Clean the external optics at least every month. Clean the internal optics at least every 30/60 days.
ATTENTION: We strongly recommend internal cleaning to be carried out by qualified worker!
5
Advertenties
Inhoudsopgave
