Download Inhoudsopgave Inhoud Print deze pagina

Evolar EVO-CF50BW Installatie-Instructies pagina 17

Inhoudsopgave

Advertenties

Remote control (emitter) operation
1
2
TroubleShooting
Fan does not work
1. Check all fuses or circuit breakers if
disconnecting the power supply to the
fan.
2. Turn off electrical power and check all
wire connections to fan and in switch
housing.It must be carried out by a
electrician
Fan is noisy
1. Assure that the screws fastening blade
arm to motor are tight and the lock
washers provided for that purpose
have been used
2. Lower the upper canopy to ensure a
separation from the ceiling of no less
than 3mm to reduce noisy
3. Check to see if any of the blades are
cracked .If so,replace all of the blades
4. If this is the first use ,leave the fan on
for at least 8 hours.In the event that
mechanical noise continues after this
period,contact certified electrician
3
Reverse switch
Fan speed
Fan on/off
Fan timer switch
Light on/off
Turn down/up
the brightness
Light color
Change
If emitter can not control the fan
1. Please check whether the battery is
installed correctly and whether it is
charged. If necessary, replace the
remote control battery.
2. Please check if there are similar
remote control products working
nearby, because remote control
products of the same frequency will
interfere with each other.
3. Use learning code matching mode is
used between emitter and receiver
Turn "ON"the supply power within 30
seconds and press the emitter,'s "
button for 5 seconds. it can load
normally after hearing a long
sound"bee", which means learning
successfully and it can works normal-
ly.
Fan turns but airflow is inadequate
1. The fan may be running in reverse, so
air is going upward.
2. The room may contain items that
obstruct the air flow.
3. The fan may be too small for size of
the room.
Fan shakes or wobbles
1. The fan blades are not parallel to the
ceiling .See Fig.1 how to inspect
2. Make sure mounting bracket is
tightened at outlet box with no move-
ment at all.
3. Make sure all screws holding the
blades to the blade arm and blade arm
to motor are tight.
4. Use the balance kit and instructions to
balance the fan. Please see the last
pages described.
.6.
"

Advertenties

Inhoudsopgave
loading

Inhoudsopgave