Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
3.
Installing the LM
Install the LM and associated components as follows:
1.
Mount the actuator (see 3.1).
2.
Mount the cable reel (see 3.2).
3.
Mount the steel wire on the cable reel (see 3.3).
4.
Mount the CE protection cover for the cable reel (see 3.4).
5.
Mount the pipe/chain coupling (see 3.5).
6.
Mount the belt drum (see Error! Reference source not found.).
7.
Mount the belt on the belt drum (see 3.6).
8.
Mount the CE protection cover on the belt drum (see 3.8).
9.
Connect the LM (see 3.9).
10. Reverse the running direction (see 3.10).
11. Set the stroke length (see 3.11).
12. Test the LM (see 3.12).
3.1
Mounting the actuator
1.
Do not mount the actuator where the weather has direct influence; not in direct sunlight, in places where the
temperature can rise sharply etc.
2.
Mount the actuator on a solid and safe surface.
3.
When mounting, the corresponding LM mounting kit can be used. (For mounting instructions see appendix).
4.
Otherwise, mark the drilling holes using the drilling jig supplied with the actuator.
5.
Seal the gland nuts after mounting to prevent the entry of moisture, dust and/or aggressive gases.
Never mount the actuator in the following position:
Gnd
g
3
Advertenties
Hoofdstukken
Inhoudsopgave
