Inhoudsopgave
Advertenties
III . OPERATION
WARNING
!
• Do not inhale any smoke emitted from the
tool or battery pack as it may be harmful.
[Main Body]
Switch and Forward/Reverse
Lever Operation
Forward
Switch lock
CAUTION:
To prevent damage, do not operate
Forward/Reverse lever until the bit
comes to a complete stop.
Forward Rotation Switch
Operation
1. Push the lever for forward rotation.
2. Depress the trigger switch slightly to start
the tool slowly.
3. The speed increases with the amount of
depression of the trigger for efficient tight-
ening of screws. The brake operates and
the bit stops immediately when the trigger
is released.
4. After use, set the lever to its center posi-
tion (switch lock).
Reverse Rotation Switch
Operation
1. Push the lever for reverse rotation. Check the
direction of rotation before use.
2. Depress the trigger switch slightly to start the
tool slowly.
All manuals and user guides at all-guides.com
3. After use, set the lever to its center posi-
How to Use the Belt Hook
• Be sure to attach the belt hook securely
• Periodically check screw for tightness. If
Reverse
• Be sure to attach the belt hook firmly and
• When the main unit is held by the belt
• When the belt hook is not used, be sure
• When the unit is hooked onto the waist belt
To Change the Belt Hook
Location Side
The belt hook can be attached to either
side of the unit.
1. Removing the hook
2. Attaching the hook to the other side
- 11 -
tion (switch lock).
CAUTION:
• To eliminate excessive temperature
increase of the tool surface, do not oper-
ate the tool continuously using two or
more battery packs. Tool needs cool off
time before switching to another pack.
WARNING
!
to the main unit with the screw firmly fas-
tened. When the belt hook is not firmly
attached to the main unit, the hook may
disconnect and the main unit may fall.
This may result in an accident or injury.
found to be loose, tighten firmly.
securely onto a waist belt or other belt. Pay
attention that the unit does not slip off the
belt. This may result in an accident or injury.
hook, avoid jumping or running with it.
Doing so may cause the hook to slip and
the main unit may fall.
This may result in an accident or injury.
to return it to the storing position. The belt
hook may catch on something.
This may result in an accident or injury.
by the belt hook, do not attach driver bits
to the unit. A sharp edge object, such as a
drill bit, may cause injury or an accident.
(1) Remove the nut.
(2) Draw out the hook.
(1) Insert the hook in the other side.
(2) Tighten the nut fully so that it
securely fastened.
Advertenties
Inhoudsopgave
