Advertenties
Outdoor sensor reception
-
While doing initial operation or manual reception, the outdoor reception mode will be entered for 3 minutes and
the reception symbol
Press the – button for 3 seconds to start outdoor reception mode manually.
-
-
The outdoor reception mode was successful once every channel displays values and the reception symbol
will be displayed permanently on the display.
Note:
-
When sensor data in each channel not receives the same ID code within one hour, the channel will display the
last received value flashing, then enter 3 minutes outdoor receiving mode. After one hour, it will clear ID code
then enter 3 minutes RF receiving mode, at this time the display in which channel will display --.-, clearing the
Max/Min value. It will repeat until a signal is received.
-
When the sensor data was lost, but the signal received again, the sensor date will be displayed and the
MAX/MIN value recorded
MIN/MAX values
-
The lowest and highest values in each channel will be recorded and can be displayed at any time.
-
In normal display mode, press the +/MAX/MIN button once to display the MAX values in each channel.
-
Press the +/MAX/MIN button once again to display the MIN values.
-
Press the +/MAX/MIN button once again to return to normal display mode.
-
To clear all recorded values, press the +/MAX/MIN button for 3 seconds and the values on the display will
vanish for 1 second to indicate successful MAX/MIN clearing.
Displayed Temperature unit
-
In normal display, press the -/C/F button to change the temperature unit between °C and °F.
Temperature and humidity range
-
Indoor temperature scope: 32℉～122℉（0℃～50℃）
-
Testing cycle: 30 seconds
-
Outdoor temperature scope: -58℉～122℉（-50℃～50℃）
-
Indoor/Outdoor humidity scope: 20%～95%
-
When temperature value higher than scope it will display HH.H and when temperature lower than scope it will
display LL.L.
-
When humidity value higher than scope it will display 95% and when humidity lower than scope it will display
20%.
Low battery indicator
When batteries in outdoor sensors or the main station are starting to run low on energy, the low battery indicator
Manual – WS 7060
will flash.
- EN04 -
Advertenties
