Inhoudsopgave
Advertenties
EN
If the pump is lowered into a water tank whose bottom is contaminated with e.g. sand or
sludge, or the water tank does not have a hard bottom, ensure that the pump is not lowered
all the way to the bottom. The impurity suction pump will then work less effi ciently. In addition,
contamination will lead to faster wear of the pump. Excessive contamination can lead to
blockages in the pump's inlet openings, which can cause damage to the pump.
It is forbidden to immerse the pump in water bodies with people in them.
If the pump is submerged in water bodies with a small surface area, e.g. a well, the minimum
dimensions of the tank at the pump's workplace are given in the technical data table.
The submerged pump must be positioned vertically. Tipping or tilting the pump leads to mal-
function, reduces performance, and can also result in damage to the pump.
It is forbidden to drill any holes in the device, as well as making any other modifi cations of the
device not described in the manual.
Move the product by grasping the handle or housing. Do not move the device by pulling on
the power cord.
Recommendations for connecting the appliance to the power supply
Warning! The pump shall be supplied by a residual current device (RCD) with a rated diff er-
ential current of not more than 30 mA.
Before connecting the appliance to the power supply, make sure that the voltage, frequency
and performance of the power supply corresponds to the values shown on the appliance's
rating plate. The plug must fi t into the outlet. It is forbidden to modify the plug in any way.
The power supply circuit must be fi tted with a protective conductor and at least a 16 A pro-
tective device.
Avoid contact of the power cord with sharp edges, hot objects or surfaces. During operation,
the power cord must always be fully extended and the position of the power cord must be set
so that it does not become an obstacle during operation. The power cord shall not be placed
a manner that would pose a risk of tripping. The power supply socket should be located in a
place where it is always possible to quickly remove the appliance power cord plug. Always
pull the power cord by the plug housing when unplugging it, never by the cord.
If the power cord or the plug are damaged, immediately disconnect it from the power supply
and contact an authorised service centre of the manufacturer for replacement. Do not use
the appliance with a damaged power cord or plug. The power cord or plug cannot be re-
paired and must be replaced with a new one that is free of defects if these components are
damaged.
DEVICE OPERATION
Connecting the outlet hose
The water outlet is equipped with a thread to which a hose connector must be connected. You can use the connectors provided
with the pump or available separately. If a hose with the inside diameter smaller than the water outlet diameter is used, the pump
capacity will decrease. The connector included in the pump equipment has the possibility to connect hoses of diff erent diameters.
When connecting a hose with a diameter larger than the smallest diameter of the connector, cut off the smaller diameter part of
the connection so as not to restrict the fl ow of the pump. The connector is made of plastic, so the cut can be made with a sharp
knife. Be careful when cutting to avoid injury.
The hose connector must be screwed on without tools with suffi cient force to ensure a tight connection. Use of excessive force
can damage the gasket.
O R I G I N A L
I N S T R U C T I O N S
12
Advertenties
Inhoudsopgave
