Inhoudsopgave
Advertenties
UK
SAFETY, INSTALLATION AND MAINTENANCE
INSTRUCTIONS
KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
DANGER- To avoid possible electric shock, special care should be taken if water is employed
in the use of vivarium equipment. For each of the following situations, do not attempt repairs
yourself; return the appliance to an authorised service facility or discard the appliance.
This product is designed for indoor use and the illumination of Vivariums and Aviaries only and
will provide a good and safe service life, provided that these instructions are followed. Failure to
do so may result in serious personal injury or property damage.
If you are in any doubt about the installation or operation of this product, please consult a
qualified and experienced electrician.
Check that the voltage and frequency rating on the product label is the same as your electrical
supply before proceeding further.
WARNING- To guard against injury, basic safety precautions should be observed, including the
following:
• Disconnect from the mains supply socket before maintaining the Luminaire. Never pull on the
cord to remove the plug from the socket, instead grasp the plug and pull to disconnect.
• Regularly check the security of all your Luminaire legs or suspension mechanism parts.
• The Luminaire can get HOT. Never touch the Luminaire while it is operating, allow adequate
time for it to cool before attempting any maintenance.
• If electrical components of the appliance get wet unplug the appliance immediately. If the
appliance shows any sign of water leakage disconnect from the power supply immediately.
• Do not operate the Luminaire with defective or faulty lamps – circuit damage may occur.
Replace lamps promptly with a lamp of the correct type and wattage. It is advisable to keep
spare lamps available.
• Do not use the appliance other than for its intended use. The use of non-Arcadia attachment or
accessories is not recommended and may cause an unsafe condition.
• Do not install or store the appliance where it will be exposed to extremes of weather or
temperatures below freezing.
LAMP INSTALLATION
Ensure lamps are of the correct type and wattage.
To remove the lamp, pull the retaining ring (A) clips out and up to remove it from the lamp holder.
PHYSICAL INSTALLATION
Select a suitable site close to your electricity supply. Do not connect appliance to the mains
supply socket during installation. This appliance is for indoor use only. Ensure the appliance is kept
in a ventilated area and away from other heat sources. Make sure that the light from the appliance
is aimed within the vivarium.
Place the luminaire in the desired position either on top of the Vivarium mesh or screwed to the
top of the Vivarium (2 screws not supplied).
Ensure the mains lead and the luminaire are kept well out of reach of animals that might bite or
damage them.
ELECTRICAL INSTALLATION
Before installing, ensure that the rated voltage and frequency of the Luminaire match that of your
power supply, and that the mains lead plug is fully compatible with your mains supply socket. If in
doubt, please return the unit to the point of purchase for verification.
Plug the luminaire into the mains socket.
Use the switch on the driver to turn the luminaire on/off.
A suitable plug in timer may be used with this product, such as the Classica CAA01 or CAA02.
TROUBLE SHOOTING
Lamps strike almost immediately at nearly full brightness (dependant on ambient temperature)
and reach their operating temperature soon after. After switching the fluorescent lamps off, they
can be switched on straight away.
If the Luminaire does not light:
• Check that the mains power is connected and switched on both at the wall (including Timer if
used) and on the Luminaire.
• Check that the Luminaire plug is properly fused.
• Check that the Luminaire is rated for the same supply voltage that you are using.
Advertenties
Inhoudsopgave
