Inhoudsopgave
Advertenties
EN
CARBEST Gas Cooker l 70178-70181 / 70183 / 70557-70559 / 70561-70563 / 70567-70569
Inserting and fastening the appliance
Remove the appliance from the packaging, ensuring that it is complete and undamaged. If in doubt, do not
proceed and contact the dealer of Technical Assistance immediately. Remove the protective plastic.
CAUTION: The material of items adjacent to the appliance (e.g. furniture) must resist tempera-
ture surges of at least 65 K (90°C with a room temperature of 25 °C).
Make a hole in the surface of the unit in which you wish to install the appliance.
Also observe the critical distances from the adjacent walls/furniture.
Hole size (L x P ) to house the appliance and critical distances (X and Y) vary from model to model. See
table and figure 3 below.
Please Note: In figure 3, the side of the furniture is shown to the left of the appliance. If you wish to install it
on the right, observe the same critical distances indicated in the table (Y).
Make sure that the distance between the pan stand of the appliance and any furniture of hoods above the
appliance is at least 650 mm. Any lateral work surfaces within critical distance Y must remain below the
height of the appliance surface.
When the appliance is in use the bottom may feel hot, while remaining within the limits indicated by the ref-
erence standard (EN 30). To prevent accidental contact it is possible to install a divider (separator panel) at
least 20 mm (but not more than 150 mm) from the bottom of the appliance.
Please Note: Before inserting the appliance, connect the gas as described in the following
paragraphs.
21
Advertenties
Hoofdstukken
Inhoudsopgave
