Advertenties
Changing the mode
You change the mode by rotating the mode selector switch on your flight stick.
As you do this, the MODE number displayed on the MFD changes to reflect your selection.
Using additional modes
Three modes are available by default. You can increase this to six using the pinkie switch
on your flight stick. To do this you must designate the pinkie switch to perform the same
function as the Shift key, using the SST programming software. You can then select one
of the additional modes by holding down the pinkie switch as you rotate the mode selector
switch. When you do this, the word SHIFT is displayed in the mode section of your MFD.
Within each profile, you can use the following modes:
• Mode 1
• Mode 2
• Mode 3
• Mode 1 + Pinkie
• Mode 2 + Pinkie
• Mode 3 + Pinkie
Viewing the current modeThe mode that is currently selected is displayed in the top part
of the MFD. This is shown in the following example:
14
Advertenties
