Inhoudsopgave
Advertenties
in % will be shown and if 100% are reached an acoustical signal appears as a signal to stop tanning. Using the Sun-
Counter can make a contribution to avoid sun burns, risks of early skin aging and increased risk of skin cancer.
Operation of SunCounter
On/Off-button
Switch on the unit
By a little longer pressing of the ON/OFF button the instrument can be switched on. An acoustical signal appeared and
the display can be activated. Afterwards the following adjustments/measurements can be carried out.
Measure UV Index and ambient temperature
The SunCounter should be laid down under sunshine that the lens is directly
facing the sun.
The Meas./Adj. button has to be pressed for 2 seconds until the Sun sign and
Temperature reading are flashing, then the Meas./Adj. Button has to be
released.
After 3 seconds the sun sign is gone and temperature reading stop flashing.
The UV Index and temperature can be read now.
Setting the Sun-Protection-Factor and select the Skin Type
Press SPF/SKIN-button once till SPF icon is flashing.
Press Meas./Adj.-button to adjust the SPF value (Sun-Protection-Factor) from 0 up to 100.
Press SPF/SKIN-button again till Skin Icon is flashing.
Press Meas./Adj.-button to select Skin type from 1 to 4. Refer to following table for correct skin type.
Press SPF/SKIN-button again to set above values.
All manuals and user guides at all-guides.com
- 9 -
UV-sensor
LCD-display
SPF/Skin-button
Meas./Adj.-button
Advertenties
Hoofdstukken
Inhoudsopgave
