Inhoudsopgave
Advertenties
Device-specific additional instructions for nailer
4
Filling the magazine
Ensure that nailer and fasteners are compatible (Chap. 1) with
each other.
Check fasteners for proper condition.
Put nailer carefully down in defined safe resting position
(Chap. 3): The driving nose must point away from any
person. It must be impossible to unintendly actuate trigger
and/or release protection.
Press the latch button 1 and push the magazine cover 2 to
the rear. Insert the round head nails with the tips at the
bottom into the magazine 3. Then push the magazine cover
2 forward
.
5
Removing stuck fasteners from the driving channel
Disconnect the tool from the compressed air supply. Remove the
staples from the device. Actuate the locking lever 1 and open
the head piece flap 2. Remove jammed staples. Close the head
piece flap 2 again, connect the tool to the pressure supply and
refill the magazine with staples.
6
EU Declaration of conformity
The BeA GmbH, manufacturer or importer, address as on cover sheet, declares under sole responsibility this product's conformity with all
relevant provisions of the EU Machine Directive 2006/42/EG. The following standards are applied:
EN ISO 12100:2010 (Machine safety); ISO 11148-13:2017-11 (Hand-held non-el. machines - Fastener driving tools);
EN 12549:1999+A1:2008 (Noise measuring for driving tools); ISO 28927-13:2022-02 (Vibrations at driving tools).
------------------------------------------
Dr. Jörg Dalhöfer, CEO
SK350-224C
-----------------------------------------------------------
Joachim Bauer, Documentation responsible
EN - 13
Advertenties
Inhoudsopgave
